Installing the Combi-Cam Wood Installation Metal Installation      The Combi-Cam replaces a standard keyed 3/4 diameter cylinder.  For new applications, drill a 3/4" hole Insert the cylinder body through the front. Note:  Be sure the set pin hole is at the bottom (red arrow) Back View of installation and cylinder. Place the Wood Prong Washer  Tighten the 3/4" cylinder nut securely  Prongs will grip the wood.  In addition, you have the option of Installing small screws in the holes provided in the  Wood Prong Washer. Insert Dial Face Module through the front of the Cylinder. NOTE: Make sure the black rubber ring goes around the shaft as is inserted through the hole. NOTE: Also make sure the reset button on the dial face is at the bottom (red arrow)   Cam Stop Placement For the cam to rotate to the right (as you face the front of the lock) Cam Stop Placement For the cam to rotate to the left: (as you face the front of the lock)   - Short cam can be placed in increments of 90 degree positions (shown above).  - Long cam can be positioned in increments of 45 degrees. - Both cams have a 90 degree turn. Tighten the screw and lock washer.  If screw is over tightened, face becomes hard to turn.   Following the Wood Installation instructions with the exception of the following steps: Step One: Installation will either be replacing or the metal will be punched.   Please note the punch template to the right (comes with product instructions). Step Two: Wood Prong Washer not required.

 

GLOBAL NAVIGATION   Home | Features | Applications | Specifications   Demo |  Testimonies	OTHER PRODUCT LINES ShurLok Key Storage- Never be locked out again! ShurLok Combination Key Cabinets - Why use keys to access keys? The HitchSafe- Converts vehicle receiver into a vault! SOBO Locks- European style High Security Padlocks Comb-Bolt-  Barrel bolt with 10,000 combinations
| FAQS
© 2003 Combi-Cam